We paint a shed - a utility block in the country with an airbrush with our own hands. Exterior paint for wood

Everyone who lives in the private sector, as a rule, has a barn on the site, which can be used in a variety of ways. This utility room must be looked after in order to provide it with a decent appearance and good performance. Often, sheds are built of wood, so care must be taken with it, because wood requires special protection from impacts. environment. The main type of finishing of the barn is its coloring, which is desirable to perform immediately after construction.

Many people think about what paint to buy for the barn? The choice here is quite large, because almost any wood paint for outdoor work is suitable.

Acrylic paint is the most common type of paint composition, which is optimal for painting a wooden shed. It has environmental friendliness and natural composition, natural, safe for human health and the environment. Painting acrylic paint allows you to reliably protect the tree from moisture and other negative atmospheric influences, give it the properties of frost resistance, breathability. Durable coating retains its saturated color for the entire period of operation - up to 10 years. Acrylic paint is easy to apply and dries quickly, without emitting any odors, but you can work with it only at positive air temperatures.

Oil paints can also be used to paint sheds outside. They can be applied even sub-zero temperatures, and the dried layer will hold firmly and firmly. But the disadvantages of oil formulations are also present - a toxic, pungent odor, a high probability of smudges on the surface, a long drying time, the need to completely remove oil paint before subsequent painting.

Alkyd paint for the barn and its features

Alkyd paints for wood in outdoor conditions have been used for a very long time. They have a fairly low cost, which is one of the reasons for their popularity. On the surface they form thin film, which repels water and protects the wood from atmospheric influences. One of the disadvantages of this type paint is its fragility, because it dries too quickly and does not have time to penetrate into the deeper layers of the material. Alkyd paints are extremely frost resistant, but should only be applied to dry surfaces.

IN country design even utility blocks can be not just a barn, but a real work of art. I bring to your attention interesting ideas utility sheds, houses for inventory and workshops. All these structures can be made to give with your own hands, decorate to your liking.

Hozbloki can be without windows to prevent easy theft of the tool if your site is located in a not very quiet place.

The wall of the shed can be decorated with painted plastic plates screwed on with self-tapping screws. At my dacha, the northern wall is decorated in this way, I painted them myself.

Your workshop can be small porch where you can sit and take a break from country affairs and worries.

The classic design of a cute hozblok, decorated with ampelous flowers, as well as tub and tray compositions.

The octagonal guest house can be used both as a workshop and as a utility block.

Hozblok combined with a garage. Even a shed can have beautiful front garden with flower beds.

A stylish guest house made of foam blocks can also serve as your workshop.

Here's another one nice idea hozbloka enthusiastic summer residents. Doors, as I like, with floor-to-ceiling glazing.

A wonderful idea for a utility block combined with a guest house.

The idea of ​​imitating windows with trays of flowers will revive plain walls barn.

A nice composition of a shed and a pergola with a seating area.

Classic barn in the country or private courtyard.

Still, it's nice that there are people who create beautiful landscape design solutions from ordinary, familiar buildings.

It would seem like a barn, but here is the porch, here are the flowers - and already a completely different feeling! Some joy...

If the shed is painted in light shades, then the site will immediately become more fun.

Old tools can be hung on the walls, decorating them in a rural country style.

Neat guest house, lined with shingles.

A beautiful idea for a shed in the country is a flower bed and flower trays, a stone slab path leading to the building.

high barn with shed roof and windows for light from the ceiling.

The original hozblok for storing inventory in the country.

Workshop idea for suburban area- I can assume that the artist creates his masterpieces here!

natural roof in scandinavian style- in Norway, on old houses you can find turf. Well, here the designer's idea was to plant a flowering lawn.

Some ideas are so good that they can even form the basis of a small country house, not the hozbloka.

In the photo - a completely working option for summer house on a 6 acre lot.

Wenge-colored shed - stylish solution in color!

A stone hozblok in an English estate is a construction for more than one century, and more than one century is ahead!

A simple idea for a shed for storing inventory in a summer cottage.

Beautiful frame shed, sheathed with plywood.

A squat hozblok is a design idea for your dacha.

The original solution is an imitation of shutters on the window.

You can make such hozbloks with your own hands in a week, thus you will find a place where you can store the tool. But do not turn the room into a pantry!

The idea of ​​designing an approach to outbuildings in the country.

It would also be good to provide a canopy over the door so that in the rain you can open the door without standing under falling drops of water.

An unusual solution for the entrance group made it possible to create an additional door.

A solid barn built in Western style.

The idea of ​​the hozblok is a square-shaped workshop.

The idea of ​​a hozblok with an asymmetric roof.

Hozblok with a beautiful front door on massive loops.

Unusual hozblok with walls made of wood cuts. I have already met a similar solution many times, I wonder how labor-intensive and reliable it is?

On this, let me say goodbye to you today, see you tomorrow! Stay tuned for updates, share ideas with your friends, get inspired and create unique beauty on your site!

wooden buildings on personal plot should not only be protected from the weather, but also look decent.

Therefore, their facades must be periodically painted. I'll tell you how to do it without much straining.

Painting a wooden shed: background

Our rather spacious utility block measuring 4 x 5 m with a small veranda, divided by a partition into two rooms, each with its own entrance, was built first and was initially used for living. They treated him carefully and carefully watched his appearance.

But over time, other buildings grew on the site, so that hands and funds were not enough to maintain in perfect order all objects. Because of this, the re-painting of the walls of the utility block outside began much later than it should have. old protective covering it peeled off in places, these areas darkened greatly, and the sheathing boards themselves were noticeably warped from rain and sun. In such a situation, it was decided not to grind the surface of the skin and not to wash off the old rather light coating from it, but only sweep the walls with a brush from dust, cobwebs and peeling paint. For finishing, they chose the Aquatex-Extra protective coating in the Kaluzhnitsa color - darker than it was before.

The mother-in-law heroically took up the finishing of the utility block, because in her youth she worked for some time as a painter at the factory, but demanded that she buy an airbrush. Before that, we usually managed with a brush and a roller.

But ordered - done. We chose an inexpensive, although not the cheapest model of the Defort DSG-400 spray gun with a built-in fan. The paint is fed into the sprayer nozzle by a powerful air stream created by a fan (as in a hose nozzle for domestic vacuum cleaners).

Therefore, the number of parts of the spray gun that must be thoroughly washed after work is much less than that of a similar tool with piston pump. In our case, the torch at the outlet of the atomizer is formed in the form of an oblong oval rather than a cone. In this case, by turning the bell, you can choose the vertical or horizontal direction of the long axis of the oval of the torch. In one pass, a uniform, quite thin layer coatings.

But the work is moving fast. It took less than an hour to paint in one layer of gables and walls - however, five layers of paint had to be applied to make the result opaque. A serious drawback of the composition used for finishing is a significant holding time before applying the next layer. I had to "catch" the weather without rain and strong wind. But we were quite satisfied with the result.

Painting the hozblok with an airbrush: photo

Paint a wood shed with a spray gun: work progress

The powerful (400 W) spray gun turned out to be quite light: together with paint (0.8 l), it weighs less than 2 kg.
The viscosity of the paint was checked using a VZ-4 viscometer. It is measured in seconds.

Filling the viscometer cup with paint to the brim, we measured the time during which it would flow out through the lower hole 0 4 mm. Depending on the type of paint used, the viscosity should be in the range of 18-35 s. We didn't have to thin the paint.
Before starting work, you need to protect yourself from getting sprayed paint on the skin, eyes and lungs. A protective suit, gloves, goggles and a respirator coped with this. Having connected the filled spray gun, they checked its functioning.

Holding the spray gun at a distance of 25-30 cm from the surface to be painted, alternately moving up and down and right and left formed a layer of protective coating.

Each time going up or down the stairs, the location of the power cord of the tool and extension cord was monitored, since they are energized.
After disassembling and washing the parts of the spray gun, a small amount of solvent was washed into its reservoir and, having assembled the tool, the solvent was sprayed to clean the nozzle.

Natural wood, thanks to its high performance and attractive appearance For many years, it has been an indispensable material during the execution of almost any construction and finishing work.

At the same time, natural wood is a rather vulnerable material, which, in order to ensure its durability, needs careful maintenance and additional protection from impact. external factors environment.

Painting of wooden structures

At present, exterior paint on wood is the most common means of dealing with harmful effects natural factors, so this article will discuss the main properties, as well as the positive and negative sides various types paint compositions.

In addition, the reader will be presented detailed instructions, which will help determine the choice of the most suitable paint for use in certain conditions.

Why paint wood

By itself, the process of staining wood involves applying a paint and varnish composition to its surface to give the product or structure certain color and improve its appearance.

However, before painting wooden windows outside or any other wood products, it is necessary to study the basic properties of paints and varnishes for outdoor use.

1. The main purpose of coating compositions (paints, enamels) is to give the desired shade or color to the treated surface.
2. Coating with translucent compositions (impregnations, stains) allows you to emphasize the natural texture natural wood, and also give it the necessary shade.
3. Transparent or tinted varnishes and mastics make it possible to leave the natural texture of wood visible and at the same time emphasize its depth, and in addition create an additional layer on the surface of the material. protective film.

Choosing what to paint wooden bath outside or a house, for example, you should know that modern, in addition to the decorative function, perform a number of other tasks that are aimed at increasing durability, safety and reliability of operation wooden structures.

1. The main task of all paint and varnish compositions for outdoor use is to protect the surface of wood from penetration into its thickness. excess moisture due to exposure to precipitation or high humidity air.
2. Paints and impregnations containing antiseptic substances in their composition prevent the formation and reproduction of putrefactive bacteria, mold fungi, insects and other pests on the wood surface.
3. The paint film protects the wood from premature aging due to exposure to ultraviolet radiation.

Special formulations

In addition to the familiar and fairly common paints, enamels and impregnations on a water or organic basis, there are special paints and varnishes that are designed to solve specific problems and have a more narrowly focused scope.

1. Paints based on silicone resins are absolutely impervious to moisture and resistant to UV radiation. Differ in the increased elasticity, and also ability to push away any kinds of pollution.
2. Polysilicon compositions for water based do not let moisture in, but thanks to the vapor-permeable film, they allow free exit of excess moisture to the outside, while preventing rapid drying and, as a result, cracking of the wood. The main disadvantage is their rather high price.
3. Lime paints have high antiseptic properties and are well suited for treating damp and poorly ventilated areas, however, due to their low resistance to atmospheric precipitation, they are not recommended for use under open sky.
4. Special compositions, for example, fire-retardant paints for metal Polistil, are no less effective for wooden structures and allow them to provide additional protection from high temperatures.

Advice!
It is recommended to prime the most critical elements and components before painting.
As a primer, electrically conductive paint Zinga, which contains microscopic particles of zinc, is perfect.

Paint selection

Among the wide variety of modern paints and varnishes, at least importance for high-quality application of a decorative and protective coating has right choice paints.

In order to have an idea of ​​which compositions are best used when painting with your own hands in each case, a description of the scope of the most common outdoor paints will be given below.

1. Transparent paints, impregnations, stains usually have a penetrating effect and do not leave any film on the surface. The paint base, together with the pigment and the protective substance, is absorbed between the wood fibers, penetrating inside to a sufficient depth. Such compositions are characterized by high vapor permeability and contribute to high-quality drying of wood. Suitable for processing large surfaces, such as the walls of a log cabin, gazebos or baths.

1. Paint on organic solvents(oil, alkyd, polyurethane) after drying, they form a thin film of polymeric substance on the treated plane, which creates mechanical protection from the influence of natural factors. This coating has a high resistance, can give products saturated bright colours and is well suited for those that are operated outdoors, for example, garden tables and benches, window frames, fences and gates.
2. Water-based emulsions (acrylic, acrylate) after application form a thin protective film on the surface, which prevents the penetration of moisture. Due to its availability and environmental safety received wide use as finishing material for painting facades residential buildings and utility buildings. Due to its low cost, it is an excellent option for those who do not know how to paint a wooden shed outside to protect it from rain and sun.

Note!
The most common and inexpensive water-dispersion facade radiation, therefore, over time, they can fade in the sun.

Conclusion

As can be seen from this article, there are currently enough big choice materials for decorative and protective coating of wood products that are operated under the influence of natural factors.

For getting additional information on the question you are interested in, you can watch the video in this article or read similar materials on our site.